QSC PLD Guia De Inicio Rapido página 6

PLD Amplifi er Signal Flow
Input Settings
1
Sensitivity
A/D
Switch
2
Sensitivity
A/D
Switch
3
Sensitivity
A/D
Switch
4
Sensitivity
A/D
Switch
EN
Menu Tree
Presets
Preset Recall
Preset Save
Preset Wizard
*For QSC Line Arrays only.
AC Power On
After connecting the outputs to the loudspeakers, you may turn the amplifi er on.
1. Make sure the output gain settings for all audio-source devices (CD Players, Mixers, Instruments, etc.) are at the lowest output (max attenuation).
2. Turn on all audio sources.
3. Turn the AC Mains power switch on the back of the amplifi er to ON. The amplifi er starts in the state it was in when power was removed. If the
amplifi er is in Standby or Mute All mode (Power button LED solid red or blinking), press the Power button to change the amplifi er to Run mode.
4. You can now bring up the outputs of your audio sources.
TD-000351-00-D
Source
Meter Gain Mute
Select
Source
Meter Gain Mute
Select
Source
Meter Gain Mute
Select
Source
Meter Gain Mute
Select
Button
Activated
Inputs
Input Sensitivity
Input Gain
Output Processing
High-pass Gain / Low-pass 5-Band
Filter Polarity Filter PEQ
High-pass Gain / Low-pass 5-Band
Filter Polarity Filter PEQ
High-pass Low-pass 5-Band
Gain /
Filter Polarity Filter PEQ
High-pass Gain / Low-pass 5-Band
Filter Polarity Filter PEQ
Crossover
— Figure 11 —
Outputs
Source Select
Spkr Processing
Crossover
PEQ
Delay
Limiter
Array Correction*
Load Speaker
Save Speaker
6
Amp Confi g.
RMS / Peak
A
Delay D / A
Limiter
RMS / Peak
B
Delay D / A
Limiter
RMS / Peak
C
Delay D / A
Limiter
RMS / Peak
D
Delay D / A
Limiter
Set by Preset or Wizard
Utilities
Status
Amp ID
Display
Lockout
Password
GPI
GPO
A
Meter
B
Meter
C
D
Meter
X
Meter
Y