Accessories / Spare Parts - Sundstrom SR 700 Instrucciones De Uso

2.2 Accessories / Spare parts

Fig. 2.
No. Part
1. Hood SR 561
2. Hood SR 562
3. Hood SR 520 M/L
3. Hood SR 520 S/M
4. Hood SR 530
5. Hood SR 601
5. Hood SR 602
6. Face shield SR 570
7. Full face mask SR 200, PC-visor
7. Full face mask SR 200, glass visor
8. Full face mask SR 200 Airline, PC visor H03-1012
8. Full face mask SR 200 Airline, glass visor H03-1212
9. Half mask SR 900 S
9. Half mask SR 900 M
9. Half mask SR 900 L
10. Welding shield SR 592
12. Hose SR 550
12. Hose SR 551
13. Hose SR 951
14. Twin hose SR 952
15. Helmet with Visor SR 580
16. STD Standard battery, 2.25 Ah
16. HD battery, 3,5 Ah
17. Battery charger SR 713
18. Steel net disc SR 336
19. Storage bag SR 505
20. Leather belt SR 503
20. Leather belt SR 503, Large
21. Belt SR 508
21. Rubber belt SR 504
21. Belt PVC
22. Gasket to fan
23. Harness SR 552
24. Particle filter P3 R, SR 710
3. Use
3.1 Installation
See also the user instruction for the head top.
3.1.2 Filters
Read carefully the user instructions accompanying the
filters.
Particle filter
The fan unit may be used with only particle filters P3 R
(PAPR-P3), model number SR 510 with filter adapter
or SR 710, which provides protection against all types
of particles, both solid and liquid.
Note!
• When filters are changed, both filters must be
changed at the same time.
Pre-filter
The pre-filters SR 221 protect the main filter against
excessively fast clogging. The pre-filter holders also
protect the main filters against handling damage.
3.2 Assembly
a) Battery
• Remove and charge the battery indoors at room
temperature. Fig. 5, 6, 7.
The charger carries out charging automatically in
three stages. Fig. 8.
26
1. Orange LED.
2. Yellow LED.
3. Green LED.
Ordering No.
• Put the battery back. Fig. 9.
H06-5012
H06-5112
Warning!
H06-0212
• Always recharge the battery before it has become
H06-0312
fully discharged.
H06-0412
• The charger may be used only for charging the
H06-5412
batteries for the SR 700.
H06-5512
• The battery may be charged only with a genuine
H06-6512
Sundström charger.
H01-1212
• The charger is designed only for use indoors.
H01-1312
• The charger must not be covered while it is in use.
• The charger must be protected against moisture.
• Never short circuit the battery.
H01-3012
• Never try to dismantle the battery.
H01-3112
• Never expose the battery to a naked flame. There is
H01-3212
risk of explosion/fire.
H06-4412
T01-1216
b) Belt
T01-1218
• Assemble the belt. Fig. 10, 11, 12.
T01-3003
Note!
R01-3009
Study the illustrations carefully to ensure that the belt
H06-8012
will not end up upside down or back to front.
R06-0708
T06-0701
R06-0706 c) Breathing hose
T01-2001 Read carefully the user instructions accompanying the
T06-0102 head top.
T06-0103 Full face mask SR 200
T06-0107
• Assemble the hose between Full face mask SR 200
R06-0101
and particle filter fan unit SR 700. Fig. 13, 14, 15.
T06-0104
• Check that the hose is firmly secured.
T06-0124
R06-0107
Half mask SR 900:
T06-0116
• Assemble the hose between half mask SR 900 and
H02-1512
particle filter fan unit SR 700. Fig. 16, 17.
• Check that the hose is firmly secured.
d) Particle filters
Two filters must always be used at the same time.
• Check that the gaskets in the filter mounting of the fan
unit are in place and are in good condition. Fig. 18.
• If particle filter SR 510 are used, snap it on the filter
adapter without pressing onto the centre of the
filter.
• Screw the filter into the filter mounting so far that
the adapter will be in contact with the gasket. Then
turn it about 1/8 of a turn further in order to ensure
a good seal. Fig. 19.
e) Pre-filters SR 221
• Assemble the pre-filters. Fig. 20, 21.
f) Plug kit
The Plug kit is used for cleaning or decontamination of
the fan unit and prevents dirt and water from entering
the fan housing.
Disconnect the breathing hose and the filters and install
the plugs. Fig. 35.
3.3 Operation/performance
Display
Fig. 22.
a) Battery symbol that lights up with a yellow light when
the battery capacity is low.
b) Triangle that lights up with a red light if the air flow
should cease or if the filters are clogged.