Operating the outdoor sensor
♦
Open the battery compartment
ance by sliding the battery compartment cover
direction of the arrow.
♦
Insert two type AAA batteries into the battery compartment
as shown.
♦
Close battery compartment
lights up briefly and the current temperature, humidity and the
set radio channel (e.g. CH 1) are shown on the display
The control LED
that transmission is in progress.
Operating the weather station
♦
Open the battery compartment
ance by removing the battery compartment cover
♦
Insert three type AAA batteries into the battery compart-
ment
as shown.
♦
Close the battery compartment
Once the power supply has been established, the display will
light up and go through a brief check of the display elements.
The weather station will now attempt to connect to the outdoor
sensor. The reception symbol
flashes on the outdoor display
AHFL 433 B2
again. The control LED
then lights up once a minute to signal
.
above the channel display
.
on the rear of the appli-
on the rear of the appli-
GB │ MT
│
in the
.
.
107
■