Adjusting The Lcd Panel Angle; Changing The Wide Screen Mode - Pioneer AVX-7600 Manual De Operación

Section
04 Basic Operations
 When the ignition switch is turned ON
again (or turned to ACC), the LCD panel
will be opened automatically.
 Removing or attaching the front panel
will automatically close or open the LCD
panel. (Refer to page 10.)
! When the ignition switch is turned OFF
after the LCD panel has been closed, turn-
ing the ignition switch ON again (or turning
it to ACC) will not open the LCD panel. In
this case, press OPEN/CLOSE to open the
LCD panel.
! When closing the LCD panel, check to
make sure that it has closed completely. If
the LCD panel has stopped halfway, leaving
it like this could result in damage.
% Press OPEN/CLOSE to open the LCD
panel.
# To close the LCD panel, press OPEN/CLOSE
again.

Adjusting the LCD panel angle

Important
! If you can hear the LCD panel knocking
against your vehicles console or dashboard,
press ANGLE () to move the LCD panel a lit-
tle forward.
! When adjusting the LCD panel angle, be sure
to press ANGLE (+/). Forcibly adjusting the
LCD panel by hand may damage it.
% Press ANGLE (+/) to adjust the LCD
panel to an easily viewable angle.
The LCD panel angle continues changing as
long as you press ANGLE (+/) and hold.
8
En
# The adjusted the LCD panel angle will be
memorized and automatically returned to the
next time the LCD panel is opened.
Turning the LCD panel horizontal
When the LCD panel is upright and it hinders
the operation of the air conditioner, the panel
can be turned horizontal temporarily.
% Press FLIP DOWN to turn the LCD panel
horizontal.
# To return to original position, press
FLIP DOWN again.
# The LCD panel returns to the original position
automatically with beeping sound 10 seconds
after operation.
Changing the wide screen
mode
You can select a desired mode for enlarging a
4:3 picture to a 16:9 one.
% Press WIDE to select the desired set-
ting.
Press WIDE repeatedly to switch between the
following settings:
FULL (full)JUST (just)CINEMA (cinema)
ZOOM (zoom)NORMAL (normal)
# When a Pioneer navigation unit is connected
to this unit, press WIDE and hold to select the de-
sired setting. Press and hold WIDE repeatedly to
switch between the settings.