Transport, Initial Operation And Taking Out Of Service; Transport; Commissioning; Storage And Recycling - Hupfer BPN-P Manual De Instrucciones

Transport, Initial Operation and Taking out of Service

Transport

4 Transport, Initial Operation and Taking out of Service
4.1 Transport
CAUTION
4.2

Commissioning

Remove the protective plastic film from the metal sheeting before using the appliance for the first time.
INFO
Before putting the appliance into operation, it is necessary to check whether it functions correctly.
The following functions are to be checked separately:
§
In all appliances: Correct functioning of total locks.
Ensure that the appliance is clean and dry before putting it into operation.
4.3

Storage and Recycling

Appliances must be kept in a dry, frost-free environment when placed in temporary storage. The platform
dispenser must be kept covered with a suitable covering material to be protected against dust ingress.
The platform dispenser kept in the storage location must be checked for damages and corrosion every 6
months.
NOTE
Before the appliance is taken back into operation, it must be clean and dry.
If the platform dispenser is to be recycled, any heating devices must be fully removed safely; recyclable ma-
terials must be separated properly and disposed of in an environmentally manner according to the local
Waste Disposal Regulations. You must contact the local waste removal agency responsible for disposal.
91365304_A0
Damage to appliances caused by improper transport
Appliances should be safely secured when transported off site inside a vehicle
such as a truck. The total locks are not suitable for securing the appliances
when they are transported in a vehicle.
If the appliances are not secured properly, there is a risk of property damage
and personal damage caused by squashing.
Secure each individual separate appliance using suitable transport securing
devices.
Disposal of packing material
The packing consists of recyclable materials and can be disposed of accord-
ingly. The different materials should be separated and disposed of in an envi-
ronmentally friendly manner. The local agencies responsible for disposal must
be contacted regarding removal
Condensation
Ensure that there is sufficient ventilation and no major variations in tempera-
ture in the storage location to prevent condensation from forming.
Platform dispenser for porcelain and lids
BPN-P | BPN-D
Section 4
Page 15