Transport, Initial Operation And Taking Out Of Service; Transport; Setting Up And Putting Into Operation - Hupfer ITW Manual De Instrucciones

Transport, Initial Operation and Taking out of Service

Transport

4 Transport, Initial Operation and Taking out of Service
4.1 Transport
ATTENTION
ATTENTION
When loading, use only hoists and load lifting devices approved for the weight of the induction
trolleyInduction trolley. Only transport vehicles that are approved for the weight of the appliance may be
used.
The induction trolleyInduction trolley is usually delivered as an assembled unit, i.e. it is completely assem-
bled including the cooling element.
The scope of delivery is specified in the shipping documents in accordance with the valid purchase agree-
ment and included with the delivery item.
4.2

Setting up and putting into Operation

DANGER
The installation and operation of the induction trolleyInduction trolley must only be carried out by the manu-
facturer or personnel authorised by the manufacturer.
The induction trolleyInduction trolley should be thoroughly cleaned with a soft cloth before putting it into op-
eration for the first time. Ensure that the appliance is clean and dry before putting it into operation.
The following appliance functions must be checked before putting it into operation:
§
the functioning of the operating elements
§
the functioning of the cooling on devices with a cooling element
INFO
91249668_A2
Damage to appliances caused by improper transport
Appliances should be safely secured when transported off site inside a vehicle
such as a truck. If the appliances are not secured properly, there is a risk of
damage to property and harm to persons caused by squashing.
Secure each individual separate appliance using suitable transport securing
devices.
Damage to appliances caused by improper transport
Induction trolleyInduction trolleys with a cooling may only be transported up-
right, because the devices can be damaged by leaking coolant.
Always transport the induction trolleyInduction trolley upright.
Hazardous electrical voltage
Electrical current can pose a considerable threat to life and physical well-
being and may lead to injuries.
Before putting the appliance into operation, check whether the local power
supply corresponds to the power supply indicated on the rating plate. If this is
not the case, do not put the appliance into operation. Do not use any exten-
sion leads in wet areas.
Disposal of packing material
The packing consists of recyclable materials and can be disposed of accord-
ingly. The different materials should be separated and disposed of in an envi-
ronmentally friendly manner. The local agencies responsible for disposal must
be contacted regarding removal
Section 4
Page 17
Induction trolley
ITW