Additional Handsets And Base Stations; Registering An Additional Handset; Answering Machine - Topcom ULTRA SR1250 ECO Guía Del Usuario Abreviada

Ultra SR1250
• 'ENTER NAME' appears in the display. Enter the name using the
alphanumeric keys.
3. Press 17 and edit if necessary the telephone number.
4. Press 17 to store the entry in the phonebook or press
3
ESC to cancel without saving the entry.
5.3 Finding and calling a number in the phone book
1. Press 16 .
2. Enter the initial letters of the name using the alphanumeric keys.
• The first name in the list with these letters appears in the display.
4 15
3. Press or repeatedly to scroll through the other numbers
in the phone book.
4. Call the subscriber found: the desired number is highlighted. Press
14
.
6 Line settings
6.1 Set country
There are various country depending settings and by setting the country
these parameters are set correspondingly. Each parameter can be set
separately also.
17
1. Press .
4 15
2. Press or repeatedly, select 'LINE SETTINGS'.
17
3. Press to confirm.
4 15
4. Press or repeatedly, select 'COUNTRY'
17
5. Press to confirm.
4 15
6. Press or repeatedly to select the country and press
17
to confirm.
7. Press 17 again to confirm.
7

Additional handsets and base stations

Up to 5 handsets can be registered to one base station. Additional handset
must be registered to the base unit before use. Handsets of a bundled
model are already registered to the base.
You can only register handsets of the Ultra range (like the Ultra
S1200C)!
7.1

Registering an additional handset

This is only necessary if you have de-registered a handset or
bought a new separate handset. You don't have to register
handsets of a bundle!
Hold down the paging key 22
seconds until the message counter display
to flash with ' '-' '.
Registration mode on the base station is now activated for approx. 3
minutes. You must perform the following steps to register a handset:
1. Press 17 .
4 15
2. Press or repeatedly, select 'REGISTRATION'.
3. Press 17 to confirm.
4 15
4. Press or repeatedly, select 'REGISTER'.
5. Press 17 to confirm.
6. Enter the base station PIN code (system PIN, default 0000) and press
17 .
• The handset will now search for the base station and register when it
has found it. Following successful registration, the display shows
standby mode and the handset name and number.
8

Answering machine

8.1 LED display
The LED display 23 on the base indicates how many messages you have
received. When there are new messages, the LED display on the base will
blink and only indicate the amount of new messages. After you have
listened to the new messages, the total number of stored messages will be
displayed. If the answering machine is switched off, the LED display
does not light up.
If the answering mode is set to answering only, '[A]' will be shown on the
display. When the answering machine answers a call or when it's
controlled by the handset '[--]' will blink on the display.
Line settings
on the base station for more than 5
23
on the base station begins
23
7