Rotary ARO14 Instrucciones De Instalación página 19

24. Internal Air Line: (If Installed) This lift is equipped
with an internal airline that provides air to both rolling
jacks and extra access point for air driven tools (Quick
Disconnect Coupler), Fig. 32. All internal air lines are
factory assembled.
25. Rear Recoil Hose Installation:
A. Attach retainer brackets for the rear recoil hose with
M8 star washer, lock washer and nut, Fig. 36.
B. Insert retainer cable through coils of recoil hose, Fig.
37. Insert each end of cable into retainer brackets.
Secure each cable end with a M6-10 cross recess pan
head screw, Fig. 36.
C. Connect one end of provided rear recoil hose to
bulkhead T-fitting at midpoint of runway. Connect other
end of recoil hose to coupling welded on rolling jack,
Fig. 33 and 34.
D. Connect elbow end of rolling jack tubing assembly to air
pump and male end to the coupling, Fig. 33 and 34.
26. Front Recoil Hose Installation:
Push Sleeve
To Runway
Bulkhead
FiTTing
Rear Rolling Jack Tubing
Air Line Tubing
To Runway
Bulkhead
FiTTing
19
Rear Recoil Hose
Elbow
End
Assembly
CONNECT TO REAR RECOIL HOSE
Air Tubing
Elbow or
Male End
Front Rolling Jack
Tubing Assembly
Front Recoil
Hose
CONNECT TO FRONT RECOIL HOSE
Rear Rolling
Jack
Pump
Fig. 33
Coupling
Recoil Hose
Fitting
Spring
Fig. 34
Pump
Elbow End
Front
Rolling Jack
Fig. 35