Blade Assembly - Dremel 670 Instrucciones De Seguridad/Operación

5716 Dremel 2.625x4.25
Note: If the collet nut and collet are not removed
from the motor shaft, the tool will not function
properly.
Step 4. Install the drive adapter on the motor shaft
and tighten.
4
To prevent damage to tool,
CAUTION
!
do not over tighten drive
adapter. Tighten the drive adapter finger tight and
then tighten an additional 1/3 turn with the wrench.
(Wrench is included with your rotary tool kit.)
12
6/18/02 10:31 AM Page 12
Step 5. Screw the attachment onto your rotary tool
until the coupling is tight against the housing. Hand
tighten only. The attachment should be oriented on
your rotary tool so that the speed control switch on
the tool is easily accessible.
WARNING
!
source before making any assembly,
adjustments or changing accessories. Such
preventive safety measures reduce the risk of
starting the tool accidentally.
WARNING
!
not match mounting hardware will run
eccentrically, causing loss of control.

BLADE ASSEMBLY

Disconnect the plug of your
rotary tool from the power
Always use Dremel Saw
Blades. Blades that do
13