Cutting Wheel Assembly - Dremel US40 Instrucciones De Funcionamiento Y Seguridad

DM 2610031544 01-14_US40 1/17/14 11:25 AM Page 10
Disconnect the plug from
W RNING
the power source before
making any assembly, adjustments or
changing accessories. Such preventive safety
measures reduce the risk of starting the tool
accidentally.
The Lock Bolt which attaches the cutting wheel
to the tool should be turned CLOCKWISE to
be loosened and COUNTERCLOCKWISE to
be tightened (Fig. 3). This bolt is reverse
threaded compared to standard threaded
fasteners.
The Dremel Ultra-Saw features two cutting
wheel positions - one position using a standard
flat wheel for all your typical straight and
plunge cuts (Fig. 4), and a second optional
wheel position for making flush cuts along
flooring or against a wall (Fig. 5).
Do not attempt to mount
W RNING
two cutting wheels onto the
tool at the same time.
Spindle Lock
Inner
Washer
FIG. 2
Standard
Flat Wheel
FIG. 4
Assembly
1. Turn LOCK BOLT with wrench provided
2. Standard Flat Wheel Assembly: Slide flat
3. Reinstall OUTER WASHER and tighten lock
4. Press spindle lock to lock shaft and tighten
Flush Cutting
(Optional)
Outer Washer
Guard Face
Standard Wheel
-10-

CUTTING WHEEL ASSEMBLy

clockwise and remove LOCK BOLT and
OUTER WASHER (Fig. 2). If the shaft
moves while attempting to loosen the lock
bolt press the spindle lock (Fig. 2).
wheel behind the guard face and mount it
against the INNER WASHER on the shaft
(Fig. 4).
Flush Cutting Wheel Assembly: Place
flush cutting wheel against the INNER
WASHER on the spindle shaft. (Fig. 5).
bolt finger tight.
LOCK BOLT counter-clockwise until tight
with the wrench provided.
Guard Face
Wheel
LOOSEN
Lock
Bolt
Wrench
FIG. 5
FIG. 3
TIGHTEN
LOCK BOLT
Flush Cutting
Wheel