Assembly - Dremel 400 Serie Manual De Instrucciones

DM 2610922740 8-04 E.qxd
Unpacking & Checking Contents
WARNING
!
making any assembly, adjustments or
changing accessories. Such preventative
safety measures reduce the risk of starting
the tool accidentally.
Separate all loose parts from packing materi-
als and check each item with the contents
listed on the carton to make sure all items are
accounted for before discarding any packing
material.
IMPORTANT! If any parts are missing, or if
you require any assistance with these
instructions, please
Consumer Service at:
1-800-437-3635
or at www.Dremel.com.
1. Remove the collet nut, collet and hous-
ing cap from rotary tool.
NOTE: Housing cap must be re-installed on
rotary tool when XPR MultiSaw is removed.
2. Install driver nut onto rotary tool shaft.
Collet Nut
Collet
Housing Cap
Dremel recommends the use of Dremel XPR saw blades. The XPR MultiSaw
comes with a saw blade for straight and curved cuts in wood and soft materi-
als up to 1-7/16" thick. The Dremel XPR MultiSaw accepts all standard jigsaw
blades, both "T" or "U" shank.
No one blade can be efficient for all cutting jobs. Different materials require different blades.
Since your saw can cut so many materials, be sure to use the proper blade for the job to
ensure proper cutting performance.
NOTE: Refer to blade packaging for information on recommended materials and blade usage.
8/10/04 8:20 AM
GETTING TO KNOW YOUR XPR MULTISAW
Disconnect the plug from
the power source before
contact Dremel™

ASSEMBLY

Installing Saw to Rotary Tool
Overthrow Nut
Blade Selection
Page 5
Description
The XPR MultiSaw attachment is for use with
Dremel™ 400 Series XPR Rotary tool only.
The Dremel XPR MultiSaw turns your rotary
tool into a multipurpose saw that will allow
you to make straight and curved cuts in a
variety of materials. Scroll cutting patterns is
now fast and easy. Using standard jigsaw
blades, you can cut soft & hard wood, ply-
wood, metal, PVC, plastic, and much more!
Housing
Saw Blade
Footplate
Allen Wrench (2.5 mm)
(for blade installation)
3. Thread the saw onto the rotary tool
housing and tighten overthrow nut
securely. Saw should be positioned so
Dremel markings on tool and saw are
facing same side.
NOTE: Be sure to align keys on tool with key-
ways in overthrow nut.
Driver Nut
Be sure to align keys on tool
with keyways in overthrow nut.
5 5
Air Vents
Overthrow Nut
Driver Nut
Rubberized Grip
"U" Shank Blade
"T" Shank Blade