Troubleshooting; Battery Charger; Battery Pack/Battery Charger Safety - RIDGID microEXPLORER Manual Del Operario

Troubleshooting

SYMPTOM
Display turns ON, but
does not show image.
LEDs on imager head
are dim at max bright-
ness, display switches
between black and
white, color display
turns itself OFF after a
brief period.
Unit will not turn ON.
Battery and Charger
Battery Pack/Battery Charger
Safety
WARNING
To reduce the risk of serious injury, read
these precautions carefully before using
the battery charger or battery.
Battery Charge Safety
• Charge only the RIDGID rechargeable
battery listed in the Accessories Sec-
tion with the RIDGID Battery Charger
(Catalog Number 30758). Other types of
batteries may burst causing personal injury
and property damage.
• Do not probe battery charger with con-
ductive objects. Shorting of battery termi-
nals may cause sparks, burns or electrical
shock.
• Do not insert battery into charger if
charger has been dropped or damaged
in any way. A damaged charger increases
the risk of electrical shock.
• Charge battery in temperatures above
41 degrees F ( 5 degrees C) and below
113 degrees F (45 degrees C). Store
charger and battery pack in temperatures
above -40°F (-40°C) and below 104°F
(40°C). Storage for a long time at tem-
peratures above 104F can reduce the ca-
pacity of the battery. Proper care will pre-
vent serous damage to the battery.
Improper care of the battery may result
battery leakage, electrical shock and burns
microEXPLORER
POSSIBLE REASON
Loose cable connections.
Imager head covered by debris.
Battery low on power.
Dead battery.
Ridge Tool Company
™ Digital Inspection Camera
Check cable connections, clean if re-
quired. Re-attach.
Visually inspect imager head to make
certain it is not covered by debris.
Charge battery.
Charge battery.
• Use an appropriate power source. Do
not attempts to use a step-up transformer
or an engine generator. Doing so may
cause damage to the charger resulting in
electrical shock, fire or burns.
• Do not allow anything to cover the
charger while in use. Proper ventilation is
required for correct operation of the char-
ger. Allow a minimum of 4" (10 cm) of
clearance around the charger for proper
ventilation.
• Unplug the charger when not in use.
Reduces the risk of injury to children and
untrained persons.
• Unplug the charger from outlet before
attempting any maintenance or clean-
ing. Reduces the risk of electrical shock.
• Do not charge battery pack in damp,
wet or explosive environment. Do not
expose to rain, snow or dirt. Contaminants
and moisture increase the risk of electrical
shock.
• Do not open the charger housing. Have
repairs performed only at authorized lo-
cations.
• Do not carry charger by power cord.
Reduces the risk of electrical shock.
Battery Safety
• Properly dispose of the battery. Expo-
sure to high temperatures can cause the
battery to explode, so do not dispose of in
a fire. Place tape over the terminals to
prevent direct contact with other objects.
Some countries have regulations concern-
ing battery disposal. Please follow all appli-
cable regulations.
SOLUTION
17