Storage; Service And Repair; Disposal; Troubleshooting - RIDGID micro CA-300 Manual Del Operario

micro CA-300 Inspection Camera

Storage

The RIDGID micro CA-300 Inspection Cam -
era must be stored in a dry secure area be-
tween -4°F (-20°C) and 158°F (70°C) and
humidity between 15% and 85% RH.
Store the tool in a locked area, out of the
reach of children and people unfamiliar with
the micro CA-300 Inspection Cam era.
Remove the battery before any long period of
storage or shipping to avoid battery leakage.

Service and Repair

WARNING
Improper service or repair can make the
RIDGID micro CA-300 Inspection Camera
unsafe to operate.
Service and repair of the micro CA-300 In -
spec tion Camera must be performed by a
RIDGID In dependent Authorized Service
Center.
For information on your nearest RIDGID In -
depen dent Service Center or any service or
repair questions:
• Contact your local RIDGID distributor.
• Visit www.RIDGID.com or www.RIDGID.eu
to find your local RIDGID contact point.

Troubleshooting

SYMPTOM
Display turns ON, but
does not show image.
LEDs on imager head
are dim at max bright-
ness, display switches
between black and
white, color display
turns itself OFF after a
brief period.
Unit will not turn ON.
14
POSSIBLE REASON
Loose cable connections.
Imager is broken.
Imager head covered by debris.
Battery low on power.
Dead battery.
Unit need to be reset.
• Contact RIDGID Technical Services De -
partment at rtctechservices@emerson.com,
or in the U.S. and Canada call (800) 519-
3456.

Disposal

Parts of the RIDGID micro CA-300 Inspection
Camera contain valuable materials and can be
recycled. There are companies that specialize
in recycling that may be found locally. Dispose
of the com ponents in compliance with all ap-
plicable regulations. Contact your local waste
management authority for more information.
For EC Countries: Do not dispose
of elec trical equipment with house-
hold waste!
According to the European Guide -
line 2002/ 96/EC for Waste Elec -
trical and Electronic Equipment and
its imple men tation into national legislation,
electrical equipment that is no longer usable
must be collected separately and disposed of
in an environmentally correct manner.
Check cable connections, clean if re-
quired. Re-attach.
Replace the Imager.
Visually inspect imager head to make
certain it is not covered by debris.
Replace battery with charged battery.
Replace with charged battery.
Reset unit. See "Maintenance" Section.
SOLUTION