Water Line; Custom Panels - Sub-Zero ICBIW-30C Guia De Instalacion

I NSTAL L AT IO N
Alignment
A NCH O R I N G
Adjust the depth of the unit to fit flush with surrounding
cabinetry. Once aligned, verify doors and drawers open
properly, then install screws in each side trim.
SCREW
SIDE TRIM
CABINETRY
FACE
FRAME
PANEL FRONT OF
THICKNESS UNIT
Anchoring.
|
6 English

Water Line

For model ICBIW-30CI, purge the water line prior to final
connection to the unit. This will remove any debris that may
be present in the tubing from installing the new water line.
Connect the plastic tubing from the unit to the house water
supply line with the fitting connection kit provided. Check all
water line fittings for leaks.
Locate the water line in the notch as shown in the illustration
below.
IMPORTANT NOTE: Water lines can not be exposed to
freezing temperatures.
NOTCH
WATER LINE
CONNECTION
W ater line (ICBIW-30CI).
PA NE L IN STA LL ATIO N

Custom Panels

Custom door/drawer panels and handle hardware must
be installed. Stainless steel panels are available through an
authorized Sub-Zero dealer.
The thickness of the custom panel can vary. A minimum
16 mm thick panel is required, but the thickness can be
increased provided it does not exceed the maximum panel
weight indicated in the chart below. The depth of each
model is 610 mm. Allow for panel thickness when planning
the finished opening depth.
PA N EL RE Q U I RE MEN T S
W EI GH T PE R PA N E L
Door (column model)
Door (tall model)
Drawer
PA N E L TH I C K N ES S
All Panels
Reveals between panels can vary, 3 mm reveals are typical.
CAUTION
When installing a panel thicker than 25 mm, the 90°
stop may be required to prevent damage to the unit
and adjacent cabinetry.
CAUTION
As reveals between cabinetry and the unit decrease,
severe finger pinching can occur while door is closing.
M AX
16 kg
Finish all sides of custom panels. They will be visible when
11 kg
the door is open.
7 kg
D-style handles are recommended. Stainless steel tubular
M I N
and pro handles are avail able through an authorized
16 mm
Sub-Zero dealer. Door handles must be located near the
edge of the panel opposite the hinge and should be cen-
tered top to bottom. Drawer handles must be located near
the top edge of each panel.