Water Line - Sub-Zero IW-30 Guia De Instalacion

IN S TA L L AT I O N
Alignment
AN CHO R I NG
Adjust the depth of the unit to fit flush with the surrounding
cabinetry. Once aligned, verify the door/drawers open prop-
erly, then install the screws in each side trim.
SCREW
SIDE TRIM
CABINETRY
FACE
FRAME
PANEL FRONT OF
THICKNESS UNIT
Anchoring

Water Line

For model IW-30CI, approximately 3'
tubing is connected to the unit with a preassembled
compression connection under the unit. The water line fit-
ting connection kit, provided with the unit, contains a
compression union fitting for connection to the household
water line.
Purge the water line prior to final connection to the unit. This
will remove any debris that may be present in the tubing
from installing the new water line. Connect the plastic tubing
from the unit to the house water supply line with the fitting
connection kit provided. Check all water line fittings for
leaks.
Locate the water line in the notch as shown in the illustration
below.
If a reverse osmosis system is used, it
IMPORTANT NOTE:
is recommended the water filtration system be bypassed by
removing the filter.
Water lines cannot be exposed to
IMPORTANT NOTE:
freezing temperatures.
NOTCH
WATER LINE
CONNECTION
W ater line (IW-30CI)
1
of / " plastic
(.9 m)
4
1 / "
4
1
/ "
4
subzero.com | 9