Valve Download; Operational Features; Opening And Closing The Valve; Preset Operation - Akron Brass Navigator Pro Instrucciones De Instalación, Funcionamiento Y Mantenimiento

7.6 VALVE DOWNLOAD

- Refer to Section 11 (Software Updates)

8 OPERATIONAL FEATURES

The Style 9323 Navigator Pro Controller is easy to use and intuitive . Once configured, the operation is simple . Basic operation of the controller is de-
scribed below .

8.1 Opening and closing the valve

To open the valve, press the green button . To close the valve, press the red button . As soon as the button is released, the valve will stop moving . To con-
tinue opening or closing the valve, continue to hold the open or close button . The only exception to this is if Auto Open is enabled . Auto Open enables the
user to fully open the valve with one press of the open button . The only time this will happen is if the valve is all the way closed and the open button is
pressed . To cancel the auto open, press the open or closed button again at any time . This will stop the valve and allow it to be adjusted to the appropri-
ate position .

8.2 Preset operation

The Navigator Pro will save up to 3 valve positions. After the positions are saved (see setup section for programming details) the preset positions can be
selected and the valve can be quickly sent to those positions . To send the valve to the preset position, simply press the ■ PRESET button . If multiple
presets are saved, the first one will start blinking . If that is the desired preset position, press the ■ GOTO button and the valve will go to that posi-
tion . If the second or third preset is desired, press the ■ Next button until the desired preset is blinking and then press the ■ GOTO button and the
valve will go to that position . The presets are labeled P1, P2 and P3 for normal operation . If CAFS is enabled, the presets are labeled D, M and W for Dry,
Medium and Wet . When the valve is at a preset position, the preset will be highlighted in green .

9 RETROFIT INSTALLATIONS

If retrofitting to a currently installed valve is necessary, refer to the appropriate retrofit kit that will contain the correct cable to adapt to an older system
as well as an independent motor driver . Contact Customer Service for more information .

10 MAINTENANCE

The 9323 Navigator Pro Controllers require very little maintenance . The display should be cleaned with water only to prevent any damage from chemi-
cals or cleaning agents . To clean, wipe with a damp soft cloth and dry . Be sure to use a non-abrasive cloth so the display does not get scratched .

11 SOFTWARE UPDATES

The Navigator Pro controller contains pre-loaded operating software in both the display and in the motor driver . From time to time it may be necessary to
update the software . There are two methods for updating the software .
1 . Update via USB port
2 . Connect to the system with AkroView to update the software .

11.1 OBTAINING THE LATEST SOFTWARE

The latest software files can be found on the 9323 product page on the website. They will be located under the "Download/Updates" tab. There are
two files that are required to fully update the system; one for the display and one for the motor driver . These will be named 93200001_RX-X .ABS and
93210001_RX-X .ABS . The appropriate software files can also be obtained by contacting Akron Brass Customer service or Technical Support .
These files will need to be saved to a USB drive (customer provided) and should be saved in the main directory, not in any sub-folders.
Page 14