Loading Ink Ribbon And Chip Key; Loading Paper - Hiti P720L Manual Del Usuario

Chapter 2. Installing and Set Up

Loading Ink Ribbon and chip key

1. Remove chip key from Ink ribbon.

Loading Paper

Install spacers in the paper flanges first when using 5x7 size paper. When using 6x4 size paper or
6 x 9 size paper, spacers are not needed.
(Note: The availability of some consumable packages may vary in different regions. Please
contact your local dealer for the availability of the consumable packages.)
1. Install the spacers in the paper flange (green)
and paper flange (black).
The two spacers are identical.
2. Insert chip key into the dock.
3. Stretch the ink ribbon and put the
ink ribbon in the holder. Insert the
ribbon until it clicks into position.
Attention: Please make sure
2. Push the flange until see the notch on left
side on paper core.
Do not remove the seal attached onto the
paper until the paper is set in the printer.
2 - 6
HiTi P720L user manual
match the color
between ribbon core
and dock on both sides.