Handling Instruction; Handling Instruction - Continued From Previous Page - Hiti P720L Manual Del Usuario

Chapter 1. Important Safety Instruction

Handling Instruction

When handling the printer, please pay attention to the followings;
Warning: Lift the printer from its box and put it onto a flat and firm table or desk.
Warning: The printer alone (without paper and ribbon installed) is weighted around 27Kgs.
Please handle the printer carefully to prevent personal injury and damage of the
printer.
Warning: When moving the printer, hold the bottom edge of the printer.
It is strongly recommended to handle the printer by at least two persons during
the transportation.
Warning: Please take caution when transporting the printer on the slippery floor.
Warning: Please make sure the power is off and the power cord is removed from the
printer before transportation.
Warning: In the case of dropping the printer during transportation, contact Hiti dealers or
service center for inspection of the printer. Using the printer with possible
damage without proper inspection may cause fire or electric shock.
Warning: Do not dismantle or remodel the printer.
Some sections of the printer contain a high voltage or become very hot. Ignoring
this warning may cause electric shock, fire, or burns.

Handling Instruction - Continued from previous page

Warning: Secure the power cable firmly while using.
Warning: The thermal head reaches high temperature during operation but it is normal. Do
not touch the thermal head by any case. Touch the thermal head may cause
personal injury or damage of the printer.
Attention: Touching the surface of the thermal head directly may cause damage to the
thermal head. Hard object getting into the printer may also cause the damage to
the printer mechanism. In such case, please do not use the printer while any
obstacle inside the printer.
Warning: Do not attempt to service the printer beyond the instruction specified in this
document. In case of irrecoverable problem, please contact Hiti dealers or
service center.
Warning: This product must be grounded at all time during operation, and always used with
the specified power cable only or the power cable accompanying this product.
If the product is used without grounding, and current leakage occurs, fire or
electrical shock may occur, and may also cause interference to radio, television,
and other similar electric appliances signal receiving.
If the proper grounding connection is not available, please contact Hiti dealers or
service center.
1 - 2
HiTi P720L user manual