Pioneer PDA-5001 Manual De Instrucciones página 10

Installation and Connections
5 Secure the connector cover onto the display with
2 of the included screw rivets.
1 Separate the screw from the rivet using a philips
screwdriver.
2 Push the rivet section through the indicated holes
cover plate and into the plasma display until it
snaps in completely.
3 Push the screw section into the rivet to secure the
connection.
6 Remove the cover on this unit.
When the cover is removed, the two connector
terminals should be clearly visible.
6
<ARE1351> En
7 Align the holes on this unit with the
3
2
8 Connect the connector cables to the respective
9 Replace the cover of this unit.
corresponding holes on the rear panel of the
plasma display and secure this unit to the plasma
display using 4 of the included screw rivets.
2
3
÷ When aligning this unit with the plasma display, be sure
to bring the two connector cables through this unit.
÷ Attach the screw rivets in the numbered order
shown above. The procedure for attaching the
screw rivets is described in step 5.
÷ When connecting this unit to the plasma display,
make sure that the cable connectors are not
pinched between the two units.
terminals located on the inside of this unit.
Make sure that connections are made correctly and
securely.
Connection of this unit is complete.
1
4