Power Save - Pioneer PDA-5001 Manual De Instrucciones

Operations

POWER SAVE

When this unit is connected to the display, you can use
the POWER SAVE function to put the power mode
automatically in standby mode when a video or computer
signal has not been detected.
(An indication will appear on the screen before the
standby mode is engaged.)
1
Press MENU to display the menu screen.
2
Press 5/∞ to select POWER SAVE, and press SET.
M A I N M E N U
P I C T U R E
S C R E E N
A L L R E S E T
P OW E R S A V E
S E T U P
M E N U : M E N U
O F F
: S E L E C T
3
Press 5/∞ to select either "VIDEO" or "PC".
Select "VIDEO" to set the POWER SAVE mode for
input from video sources, or "PC" to set the POWER
SAVE mode for input from personal computers.
P OW E R S A V E
V I D E O : M O D E 1
: M O D E 2
P C
E X I T
: S E L E C T S E T : C H
20
<ARE1351> En
S E T : N E
X T
A N G E
4
Press SET to select the POWER SAVE mode.
When "VIDEO" is selected, the POWER SAVE modes
change as follows.
3 OFF
MODE1 2
÷ When "OFF" is selected, the display will stay in
operation mode regardless of whether a
synchronization signal is input or not.
÷ When "MODE1" is selected, the display will be put
in standby mode automatically if no new
synchronization signal is input for 8 minutes.
When "PC" is selected, the PC POWER SAVE modes
change as follows.
3 OFF
MODE2 2
÷ When "OFF" is selected, the display will stay in
operation mode regardless of whether a
synchronization signal is input or not.
÷ When "MODE1" is selected, the display will be put
in standby mode automatically if no new
synchronization signal is input for 8 minutes.
÷ When "MODE2" is selected, the display will be put
in the power conservation standby automatically if
no new synchronization signal is input. However, if
the synchronization signal is restored, the display is
put back in operation mode.
5
When the setup is finished, press MENU to exit
the menu screen.
Note
The POWER SAVE setting is common to all inputs (INPUT1 to
INPUT4).
To put the unit in operation mode again
Press STANDBY/ON on the display or remote control
unit.
If "MODE 2" is selected for PC input, resuming PC
operation or pressing INPUT on the main unit or remote
control unit can also put the unit in operation mode again.
MODE1 2