Rothenberger P63-S4 Manual De Instrucciones página 13

GB
INSTRUCTION MANUAL
Fig. 2 Insert the adapter(s)
• Mount the unit on the edge of the workbench
and tighten the screw of the G-clamp until the
unit is firmly held in place
Fig. 3 Mounting using the G-clamp
Mounting without the G-clamp
• Spread out the legs and rest the socket
welding device on a flat surface, ensuring that
it is stable
Fig. 4 Using the unit on its legs
PRECAUTION
The unit must not be connected to the mains
supply and used for welding whilst the G-clamp
has not been mounted. The legs can be used to
position the unit once it has been removed from
the case, to mount the adapters when cold, etc.
Fig. 5 Safety
18
INSTRUCTION MANUAL
2) Mount the correct adapters for the
diameter of the tube to be welded
onto the heating plate
• Locate the male and female adapter halves on
each side of the heating plate and bolt them to
it using the allen key supplied with the
equipment
PRECAUTION
In order to mount the adapters onto the heating
plate, make sure that the plate is cold and that the
unit is unplugged
Fig. 6 Mounting the adapters
19
GB
3) Connect the unit to the power source
(230 V / 110 V )
Check that the red power LED lights when the unit is
plugged in.
Fig. 7 Power LED
4) Select the working temperature with the
regulator knob
• Turn the regulator knob to the working
position
SOCKET WELDER P63-S4 / P63-S5
Thermostatic Model
The thermostat-controlled model has 6 position for
the regulator knob (See Fig. 8).
0 Off
6 Working position
Fig. 8 Thermostatic model regulator knob