Power Sources - auna 10032056 Manual Del Usaurio

POWER SOURCES

This unit operates on AC 230V~ 50Hz or 6 pieces of 1.5V "C" (UM-2)
batteries. Do not attempt to operate the radio on any other power source.
You could cause damage to the unit and void your warranty.
Please be sure the power outlet you plug this unit into is working and
receives constant (unswitched) power.
A. BATTERY OPERATION
1. Remove the Battery Door.
2. Install 6 x DC1.5V "C" (UM-2) batteries (not included) according to the
polarity diagram inside the battery compartment.
IMPORTANT: Be sure that the batteries are installed correctly. Wrong
polarity may damage the unit.
3. Close the Battery Door.
Note: For best performance, alkaline-type batteries are recommended.
BATTERY NOTES AND CARE
• Danger of explosion if the battery is replaced incorrectly. Replace only
with the same or equivalent type
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-
cadmium) batteries.
• If the unit is not to be used for an extended period of time, remove the
batteries. Old or leaking batteries can cause damage to the unit and
may void the warranty.
• Do not try to recharge batteries not intended to be recharged; they can
overheat and rupture. (Follow battery manufacturer's directions).
• Do not dispose of batteries in fire, batteries may leak or explode.
BATTERY REPLACEMENT
When the output sound of this unit becomes distorted or the CD player
operation appears unstable, the batteries are weak. You need to replace
all the exhausted batteries at the same time as soon as possible to avoid
battery leakage.
B. AC OPERATION
Plug the detachable AC cord A into a standard AC outlet (230V~50Hz).
1. When the AC power cord (included) is connected to the AC Power Socket
on the back of the unit and the other end is plugged into a 230V AC~
50Hz wall outlet, the unit will disconnect the batteries automatically, and
EN
25