AVS Electronics XSATHP Manual Del Usaurio página 28

Housing Fixation - CONTXTREAM
In order to be in conformity to the security norm EN 60950-1, the fixation to the wall must be able to
support a weight of 40 kilos.
E
N
MR8
Xsat
G
Xsat
Hole for Tamper
Housing
The housing available mod. CONT XTREAM allows the location of the optional supply unit mod.
PW3 (3.4 A.) - PW5 (5A.) and of a battery up to 17 Ah 12V.
Anti-tampering
All anti-tampering of the satellite housing must be connected to the Tamper input, carefully and
correctly installing the anti-removal kit given within.
Xsat
Fixing points
Anti-removal installation
1. Drill the wall in correspondence of the hole on the bottom of the
housing locating the anti-removal
2. Insert the screw-dowel into the hole on the wall and screw the spacer
3. Insert the anti-removal on the hole on the bottom of the housing from
outside. Fix firmly the housing to the wall, checking that the spacer
screwed on the screw-dowel presses on the spring of the anti-removal
button.
- 28 -
The housing is pre-set for the mounting of
some extension board.
The picture on the left shows the position
where the various AVS accessories can be
placed.
Further to this, the fixation marks and the hole
for the anti-removal tamper and for the supply
unit are shown as well as the predisposition
for fixing the cables to the housing.
Cables fixing
points
Supply unit fixing
points