AVS Electronics XSATHP Manual Del Usaurio página 31

PSTN telephone dialer - Technical Features
The PSTN telephone dialer is directly integrated on the XSATHP board
External connections:
Protocols:
Connection of telephone line
+SA +S C NC NO OUT
VLINEE VPOT ALARM SPK
XGSM - Technical Features
External Connections:
Protocols:
Tension:
Working Temperature:
Consumption:
Board size:
Statement:
Installation
How to proceed
a. Remove supplying completely, both mains and battery
b. Insert the special plastic supports into the holes on the satellite board with the guide-rails
towards inside
c. Insert the Xgsm board on the
connector J5 making it slide
inside the guide-rails of the
supports until blocking
d. Break the predisposition
on the satellite housing
e. Make the antenna cable
pass through the hole
and insert it into the
predisposition as shown
in the picture
f. Insert the antenna and fix
it by tightening the nut
firmly
g. Connect the antenna
cable to the GSM module
h. Insert the SIM
i. Give again supplying to
the satellite
• commuted telephone line and inside derivation
• of software connection and HPWIN management
AB : to the incoming telephone line, over all possible
telephone devices of the system
A'B' : connection to all possible telephone devices of the
IN
system
A B A" B"
MIC
Note: fix the telephone cable using the special pin
• GSM channel
• Of connection to the management software HPWIN
• Nominal tension: 12 V
• + 5 °C / + 40 °C
• In quiet: 50 mA
• In transmission: 400 mA
• 93 x 15 x 60 mm
• The GSM modules used are in conformity to the R & TTE
Directives 99/05/CE as declared by the manufacturer under
its own responsibility
F3.15A
OC 1 2 3 4 5 6 7 8 TA FA
J3
USB
F5A F3.15A
RESET
J7
F3.15A F3.15A
J8
- 31 -
S1 S2
J5
J6
S4
Fixing points of the
supports for Xgsm
F3.15A F2A
E
N
G