AVS Electronics XSATHP Manual Del Usaurio página 32

PSTN and GSM functioning
If you wish a STN connection, it is necessary to connect the telephone line , if on the contrary you
wish a GSM connection, it is necessary to insert the XGSM board inside the XSATHP satellite
T is also possible to use both systems, in this case it is necessary to decide whether to make the
phone calls in PSTN or in GSM line.
The satellite is pre-set to answer the incoming phone calls allowing to make - remotely, via
E
the HPWIN software - the programming operations and the visualization of the status of the
detectors connected.
N
It does not manage any type of out-coming phone call
G
The satellite will answer after 10 rings if the call is made in the PSTN, 3 rings if the call is
performed in GSM.
Insertion of SIM Card / Input antenna connector
In order to insert the SIM Card:
1. Open the slide support
2. Insert the SIM Card into its predisposition
3. Close the slide support until fixing it completely
Sim Card
position
Before inserting and removing the SIM Card, it
is necessary to completely remove supplying
from the satellite
De-activate the pin code of the SIM card
Disable all call-transferences
De-activate the automatic answering machine
Delete all SMS on the SIM
Input of
antenna
connector
- 32 -