Zenner MULTIDATA WR3 Manual De Instalacion Y Uso página 28

Deutsch English
Level 3
Sensor type and installation point
Pulse value
Basic configuration
Model number
End of Battery lifetime
Time
Date
M-bus address
Baud rate
Reading residual energy
Input display
Error status
Software version
28
Français
Back to
H
Level 1
Recall of software version number
The software version number of the firmware
can be called in level 3 (Display „Firmware ver-
sion").
A detailed display overview including sub menus
is available upon request.
Legend
Press the button briefly
S
(S), to switch through
the display from top to
bottom. When having
reached the last menu
item the device auto-
matically jumps back
to the menu item at the
top (loop).
Press the button for
L
about 2 seconds (L),
wait for the door sym-
bol to appear (upper
right corner of the dis-
play) and then release
the button. The menu
is then updated resp.
switches to the subme-
nu.
Hold down the button
H
(H) until the device swit-
ches to another level or
switches back from the
sub-menu.