Installation; Installation - Ducting Version - ELICA CERVINA Guía De Instalación, Uso Y Mantenimiento

Installation

Installation - Ducting version

After having chosen the vent option, proceed as
follows:
• Prepare duct and conduit cut outs as needed.
• If possible, disconnect and move freestanding or slide-in
range from cabinet opening to provide easier access to
rear wall. Otherwise put a thick, protective covering over
countertop, cooktop or range to protect from damage
and debris. Select a flat surface for assembling the unit.
Cover that surface with a protective covering and place
all canopy hood parts and hardware in it.
• Determine and mark the centerline on the wall where the
canopy hood will be installed.
• Select a mounting height comfortable for the user and
mark on wall.
• Prepare duct and conduit cut outs as needed.
Remove the duct knockouts using a flat blade screwdriver
and a small hammer.
Use the screwdriver by knocking out the pannel in similar
fashion to a scalpel.
Take care of sharp edges.
Attach exhaust adaptor/damper over knockout opening with
three exhaust adaptor screws. Make sure damper pivot is
nearest to top/back edge of hood.
Remove tape from damper flap.
NOTE: The exhaust adaptor/damper can be installed up to
1 inch on either side of the hood center to accommodate off-
center ductwork. In extreme offcenter installations, one end
of the duct connector may need to be trimmed to clear the
electrical cable clamp.
Mark holes
Select the vent option that your installation will require and
proceed to that section:
Outside top exhaust
(Vertical duct– 3 1/4"x 10" Rectangular)
Use the diagram or the hood as a template and mark the
locations on the cabinet for ductwork, electrical wiring and
keyhole screw slots.
30" Model: 2-7/8"
36" Model: 5-3/4"
13/32"
7-1/2"
7-7/8"
2-1/2"
Electrical access hole
(in cabinet bottom)
Outside rear exhaust
(Horizontal duct– 3 1/4"x 10" Rectangular)
• Use the diagram or the hood as a template and mark the
locations on the cabinet for ductwork, electrical wiring and
keyhole screw slots.
2-11/32"
30" Model: 4-15/32"
36" Model: 7"
30" Model: 6-3/8"
36" Model: 8-7/8"
7
Cabinet front
Hood mounting
screws (4)
Wood shims (recessed
5" 5"
bottom cabinets only)
Vertical duct
3-1/4"
access hole
5/8"
Center line
5"
5"