Sz-St7 / Sz-St8 / Sz-Obl; Sz-Stl1 - Optika Italy SZ Serie Manual De Instrucciones

3. Connect the power supply plug to the socket on the back of
the microscope base. (Fig. 4)
8.5

SZ-ST7 / SZ-ST8 / SZ-OBL

1. Remove the base from its packaging and place it on a flat
surface. The base is already assembled from the factory and
does not require any further assembly procedure other than
that of mounting the focusing system.
2. Connect the power supply plug to the socket on the back of
the microscope base. (Fig. 4)
8.6

SZ-STL1

1. Screw the pillar on the base. (Fig. 5)
2. Tighten the screw to lock the pillar. (Fig. 6)
Page 25
F ig. 4 F ig. 4
F F ig. 5 ig. 5
F ig. 6 F ig. 6