Teka HPL-870 Guía Rápida De Uso página 48

PROBLEM
E:1 will flash on the
temperature display and an
alarm will sound. The oven
stops heating up.
E:1 will flash on the
temperature display and an
alarm will sound. The oven
stops heating up.
E:1 will flash on the
temperature display and an
alarm will sound. The oven
stops heating up.
E:2 will flash on the
temperature display and an
alarm will sound.
E:3 will flash on the
temperature display and an
alarm will sound.
E:4 will flash on the
temperature display and an
alarm will sound. The symbol
will appear lit up on the
display.
48
CAUSE
The oven door has not been
locked. The door is not
closed properly and cannot
be locked.
The oven door has not been
locked. The door lock has
not worked.
The door cannot open but
the symbol does not
come on.
You have opened the door
before it has been locked.
You have opened the door
during the pyrolytic function.
The door lock has not
worked.
The door has been locked
without a pyrolytic cleaning
cycle being programmed.
SOLUTION
Touch any sensor to stop the
alarm. Check the door and
make sure that it is closed
properly.
Touch any sensor to stop
the alarm. Call the Technical
Assistance Service.
Touch sensor – until the time
remaining for the door to
unlock appears on the clock
display. Call the Technical
Assistance Service.
Touch any sensor to stop
the alarm. You will see the
time left before the oven
can be used again on the
display. When the display
shows 00:00, close
the door before
programming the pyrolytic
function again.
Call the Technical Assistance
Service - your oven is
operating in potentially
dangerous conditions.
The door should be locked
when the pyrolitic function is
in operation.
Touch any sensor to stop the
alarm. The E:4 symbol will
continue to flash and the
time remaining until the door
is unlocked will be shown on
the display. Touch any
sensor to turn off the E:4
reading. Call the Technical
Assistance Service.