Installing With Latch System - Harmony BIG BOOST DELUXE Manual De Instrucciones

INSTALLING WITH LATCH SYSTEM

INSTALLING THIS BOOSTER SEAT USING LATCH
DOES NOT SECURE THE CHILD. THE VEHICLE'S
3-POINT LAP-AND-SHOULDER BELT MUST BE USED
TO SECURE THE CHILD IN THE BOOSTER SEAT.
You must remove the cup holder before using/adjusting
the LATCH belt system.
1. Loosen LATCH by pressing upwards on the LATCH
release button found directly under the up-front
adjuster strap while sliding the LATCH clips out from
storage area ❶. For ease of installation, extend
LATCH to its maximum length. Ensure the LATCH strap
is NOT twisted and that the LATCH
connectors are facing down.
2. Place the booster seat flush
against a forward-facing vehicle
seat, CENTERED between the
LATCH anchors.
! WARNING:
DO NOT place the child restraint
off-center of the vehicle anchors.
3. Fasten LATCH hooks to vehicle
lower anchors ensuring the hooks
are facing downwards ❷. Pull
firmly to be sure that they are
attached. Belt must lay flat and
not be twisted.
4. Tighten LATCH by pulling on the
upfront LATCH adjustment belt
while pushing the child restraint
towards the vehicle backrest ❸.
WARNING!
!
When using LATCH,
❶
❷
❸
18