Kit Assembly - Metra 95-7510 Instrucciones De Instalación

Kit Preparation
1. Cut the top (2) mounting locations
off of the climate controls
to provide clearance for the
aftermarket radio. (Figure A)
2. Secure the climate control to the
radio/climate control housing
using (4) of the factory screws
removed in step (10) of the dash
disassembly. (Figure B)
3. Secure the hazard switch
assembly to the radio/climate
control housing using the factory
screws removed in step (12).
(Figure B)
4. Attach the (4) plastic panel clips
to the mounts on the back of the
radio/climate control housing.

Kit Assembly

(Figure A)
0 1
2
3
4
(Figure B)
95-7510
Double DIN or stacked ISO radio
provisions
1. Attach the Double DIN brackets
to the Double DIN or stacked ISO
Mount radio(s) using the hardware
supplied with the radio(s).
(Figure A)
2. Attach the rear support to the
radio(s) using the hardware
supplied with the radio(s).
(Figure B)
Continue to Interface Installation
4
(Figure A)
(Figure B)