Panasonic WV-CU161C/B Instrucciones De Operación página 23

• Check that the right unit address is selected for the
combination camera when using the RS-485 mode. The
camera cannot be operated if the numbers do not
agree.
Therefore, preset data cannot be uploaded.
• Error Display
The following messages appear on the monitor when
errors occur during uploading.
Message Cause
ERROR1 Incompatibility
ERROR 3 Causes except
above
Data Title (DATA TITLE)
1. Display the PRESET DATA LOAD menu.
2. Select the desired CAM1-CAM8 position by moving the
joystick up or down.
3. Press the PRESET/SET/PROGRAM PRESET button.
The camera number and data title menu appear on the
monitor as shown below.
CAM1:
DOWN LOAD
UP LOAD
DATA TITLE
4. Select DATA TITLE by moving the joystick up or down.
Press the PRESET/SET/PROGRAM PRESET button.
The menu shown below appears on the monitor.
CAM1:
0123456789
ABCDEFGHIJKLM
NOPQRSTUVWXYZ
().,'":;&#!?=
+-*/%$ÄÜÖÆÑÅ
SPACE
5. Move the cursor to the desired character symbol in the
character symbol area by moving the joystick up, down,
right or left, and then pressing the PRESET/SET/PRO-
GRAM PRESET button. The selected character is dis-
played in the title area.
Note
Incompatibility detected
between transmission
data and camera model
while uploading.
Uploading not possible
for some reason other
than the above.
Title Area
Character Area
Space
6. Repeat step 5 to complete the data title. A title of up to
12 characters can be selected.
7. After setting all data titles, press the HOME/ESC button
to return to the Preset Data Menu.
To replace a specific character
1. Move the cursor to the title area by moving the joystick.
2. Move the cursor on the character to be replaced by
moving the joystick right or left.
3. Move the cursor from there to the desired character in
the character area by moving the joystick up or down,
and move the cursor to the desired character by mov-
ing the joystick up, down, right or left.
4. Press PRESET/SET/PROGRAM PRESET button.
The character selected in the title area is replaced with
the correct character.
To delete a specific character
A specific character can be deleted by selecting "SPACE"
to replace it in the character area.
1. Move the cursor to the title area by moving the joystick.
2. Move the cursor on the character to be deleted by mov-
ing the joystick right or left.
3. Move the cursor from there to "SPACE" in the character
area by moving the joystick up or down.
4. Press the PRESET/SET/PROGRAM PRESET button.
The character selected in the title area is deleted.
[•] (space mark) appears in place of the deleted char-
acter.
23