Panasonic WV-CU161C/B Instrucciones De Operación página 22

6. The text line LOADING blinks on the right while down-
loading.
The bar graph changing from
loading progress.
7. END appears on the right after downloading has been
completed. The progress bar disappears.
8. Editing the DATA TITLE.
For further information, refer to Data Title on the next
page.
Notes:
• Preset data for up to 8 cameras can be downloaded.
• Downloading time is approximately 2 minutes per cam-
era.
• Any previously preset data is overwritten by the down-
loaded data.
• Press the HOME/ESC button while downloading to ter-
minate downloading. ERROR 3 appears. The progress
bar disappears.
• END and error messages remain on the menu until the
next operation is performed.
• Check that the right unit address is selected for the
combination camera when the RS-485 mode is used. If
the numbers do not agree, the camera cannot be oper-
ated.
Therefore, preset data cannot be downloaded.
• Error Display
The following messages appear on the monitor when an
error occurs during downloading.
Message
ERROR 2 Lack of memory
ERROR 3 Causes except
above
22
to P displays the down-
I
Cause Note
Memory capacity was
exceeded while down-
loading.
Downloading not possi-
ble for some reason
other than the above.
Uploading (UP LOAD)
1. Display the PRESET DATA LOAD menu.
2. Select a camera number between CAM1 and CAM8 by
moving the joystick up or down.
3. Press the PRESET/SET/PROGRAM PRESET button.
The camera number and upload menu appear on the
monitor as shown below.
CAM1:
DOWN LOAD
UP LOAD
DATA TITLE
4. Select UP LOAD by moving the joystick up or down.
5. Press the PRESET/SET/PROGRAM PRESET button.
Uploading starts.
CAM1:
DOWN LOAD
UP LOAD
DATA TITLE
END
6. The text line LOADING appears on the right while
uploading.
The bar graph changing from
uploading progress.
7. END appears on the right after the uploading has been
completed. The progress bar disappears.
Notes:
• Preset data for up to 8 cameras can be uploaded.
• The uploading time is approximately 2 minutes per
camera. When uploading is completed, combination
cameras such as the WV-CS854 will move during the
initial periods to fit the new settings.
• The camera picture may change as a result of
uploaded data. Access the Camera Setup menu to
make any necessary settings.
• Any previous preset data is overwritten by the uploaded
data.
• Press the HOME/ESC button to terminate uploading.
ERROR 3 appears and the progress bar disappears.
• END and error messages remain on the menu until the
next operation is performed.
Blinking
LOADING
to P displays the
I