Connection Diagram For Paralell Operation (Cross-Current Mode) With Three-Phase Sensing Voltage - WEG WRGA-02 Manual De Instalación, Operación Y Mantenimiento

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

www.weg.net
16.2 CONNECTION DIAGRAM FOR PARALELL OPERATION (CROSS-CURRENT MODE)
WITH THREE-PHASE SENSING VOLTAGE
1
PMG
PMG
1
PMG
1
1
For connection with single phase PMG, do not connect in AX3;
ATTENTION
1. Before connecting the regulator to the generator, verify in the installation manual, the rated sensing
voltage;
2. The sensing voltage can be different than the generator phase voltage. Note the point where the
sensing voltage is taken from (middle of the phase or complete phase).
3. If the sensing voltage is not equal to the output voltage of the generator, do not make the
connections without consulting the service department.
26
l
Automatic Voltage Regulator – GRT7-TH4-R2
Generator 1
AX1
AX2
AX3
Generator 2
AX1
AX2
AX3
Generator 3
AX1
AX2
AX3
Figure 16.2 - Parallel operation with three-phase sensing voltage.
P1
S1
N
R
S
T
WRGA-02/D
P1
S1
N
R
S
T
WRGA-02/D
P1
S1
N
R
S
T
WRGA-02/D
N
R
P2
S
S2
T
S1
S2
N
R
P2
S
S2
T
S1
S2
N
R
P2
S
S2
T
S1
S2

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Wrga-02/d

Tabla de contenido