C
C
C
3
1
2
C
removed from the cleaning cartridge (see
'Preparing SmartClean System For Use').
4
Shake off any excess water from shaver
before placing in the SmartClean System.
5
Hold the shaver head side down above the
shaver holder.
6
Place the shaver into the holder (1), push
shaver back (2) and press down the top
cap to connect the shaver (3) (click).
The shaver will only fit in the SmartClean System
in one direction.
7
The battery symbol slowly blinks to
indicate shaver is charging.
8
Press the ON/OFF button on the
SmartClean System to start the cleaning
cycle. (click).
The cleaning symbol will blink.
◗ The cleaning cycle takes approximately 10
minutes. When completed, the cleaning
symbol will light up continuously and the
drying phase starts automatically.
ENGLISH
29