To turn on the spotlight, press the pneumatic button. Do the
same to turn it off.
When turned on, the programme will be activated that was ac-
tive the last time the spotlights were turned off.
If you want to change to the next colour or cycle of colours
(for example, from "slow transition" to "rapid transition"), you
must press the pneumatic button twice within 5 seconds:
- with the first command the spotlight goes off.
- with the second, the next colour cycle after the one that was
just turned off is activated.
To go back to initial display mode, you must scroll through the
various available options by repeatedly pressing the pneumatic
button.
- Check that the push buttons are enabled by the system man-
ager as in the instructions in the installation manual.
- In models with two spotlights, the on/off command affects
both spotlights.
NOTE:
all operations concerning the enabling of buttons are
the exclusive responsibility of the system manager.
Heating
To activate the installed water heating system, do the following:
Press the pneumatic button. Do the same to stop the function.
- With the pneumatic push button it is not possible to
set/modify the desired water temperature in the spa; this is
done using the control panel. Therefore, the heater (or heat ex-
changer) and the circulation pump will come on only if the wa-
ter temperature is lower than the programmed temperature.
- If preset heating cycles are already active (see the chapter
on water heating mode in the installation manual), pressing the
pneumatic button will not have any effect.
NOTE:
all operations concerning the enabling of buttons and
programming are the exclusive responsibility of the system
manager.
Ozonator
The ozonator, or ozone generator, is supplied on request. It aids
in oxidizing the organic substances that get in the water, thus
reducing the need for chemical products for water treatment.
The ozonator operates automatically and depends on the fil-
tering pump. However, when there are people in the tub, the
ozonator is shut off automatically. It remains off for 15 minutes
after the hydromassage and/or blower are shut off.
User safety
If installed by qualified personnel in compliance with the in-
structions in the installation manual, the system does not pres-
ent any risks for the user. Safety, however, is also connected to
appropriate use, according to the provisions in this manual, while
the user must assign setting/programming/maintenance to qual-
ified personnel.
It is important to make sure that the personnel entrusted with
the installation or the running of the system are qualified ac-
cording to the provisions of law, and that in particular, when in-
stallation has been completed, a certificate of compliance is is-
sued according to the laws in force.
Concerning suitability of the electrical system and of con-
nections, refer to the installation manual (see the chapter on
CONNECTIONS AND ELECTRICAL SAFETY). Periodically, the
circuit breaker switch of the system (and the one in the elec-
trical box of the spa-pak) to which the spa is connected must
be checked.
For any extra maintenance e/or repairs it is recommended
that you contact a Jacuzzi
only original spare parts.
It is advisable to have one person get in the tub at a time, be-
cause the capacity of the pipes that connect the overflow chan-
nel with the compensation tank is limited, and is also contin-
gent on the distance between the compensation tank and the
spa. With long pipes, if more than one person at a time gets
in the spa, the water may overflow out of the tub.
WARNINGS
PLEAS E CAR E FU LLY R EAD TH E F OLLOWI N G
WARNINGS.
Jacuzzi Europe S.p.A. accepts no liability for
damages arising from failure to observe the fol-
lowing directions.
This equipment must not be used by individuals (including
children) with limited physical, sensorial and/or cognitive
abilities, or individuals who do not have the knowledge
necessary for its use.
21
®
Authorized Service Centre and use