Installation Instructions - Teka Square TG Serie Manual De Usuario

GB
WARRANTY
Manufacturer is responsible of manufacturing and material defects within a warranty period of 10 years. In case of
detecting such defects, return your sink to the seller. Keep purchasing documentation during the whole warranty
period and attach it to the sink returned.
The warranty doesn't cover any spare part or accessory, enclosed into the sink kit.
This warranty does not cover defects resulting from improper or unreasonable use, maintenance or installation.
PACKAGING:
All packaging materials (plastic bags, polystyrene foam, etc.) are potentially dangerous and should be kept away from
children.

INSTALLATION INSTRUCTIONS

INSET:
1. HOLES FOR THE TAP CONNECTIONS
The sink comes with prepared pre-drilled holes of Ø 35 mm on both sides.
This lets you choose the side where you prefer to install the tap.
After deciding which side you want to use, the hole can be completed using a
DIAMOND CORE installed on a manual drill, taking care to work from the
non-visible side.
2. OPENING THE WORK SURFACE FOR INSERTING THE SINK
Place the sink upside-down on the work surface where it is to be installed.
Trace around the outer edge of the sink using a pencil.
Now move the sink and draw a dotted line 1 cm. inside the one you have just drawn using the sink as a template.
Cut along the dotted line using the appropriate tools.
3. FITTING THE SINK INTO THE WORK SURFACE
All our sinks come equipped with pre-installed mounting clamps. The following steps explain how to install the
sink correctly:
Apply a special transparent sealant around the outer edge of the sink, wherever it will come into contact with the
work surface when the installation is complete.
Make sure that all the clamps of the fastenings are facing inwards.
Insert the sink into the cut-out area of the work surface making sure it is centred. Tighten the fastenings using the
adjusting screws, starting from the centre and working in a criss-cross order.
5. INSTALLING THE FITTING ELEMENTS AND SIPHON
Follow the instructions provided with the waste kit.
STEP1 STEP2 STEP3 STEP4
INSET MOUNT
UNDERMOUNT:
1. . HOLES FOR THE TAP CONNECTIONS
The drilling will be done directly on the work surface.
2. OPENING THE WORK SURFACE FOR INSERTING THE SINK
Place the template on the kitchen worktop; mark on it with a pencil the perimeter as indicated on the template.
3. FITTING THE SINK INTO THE WORK SURFACE
Drill the holes for the bushings 27 mm from the perimeter of the hole in which the sink will be placed, insert the
4
bushings. Apply a special transparent sealant around the outer edge of the sink Insert the sink into the cut-out area