Tabla De Contenido; Introduction - HTL CLINIPET+ Manual Del Usario

CONTENTS
1 - INTRODUCTION
2 - ASPIRATION AND DISPENSING LIQUIDS
3 - HTL PIPETTING TIPS
4 - RECOMMENDATIONS
5 - RECALIBRATION
6 - PIPETTING DENSE AND VISCOUS LIQUID
7 - TROUBLESHOOTING
8 - CLEANING AND STERILISATION
9 - PIPETTE KIT
10 - SPARE PARTS
1

1 - INTRODUCTION

CLINIPET + pipettes are desig ned for accurate
and repeatable mea sure and transfer of liquids
of constant volume from 2 to 1000 μl.
Liquid is aspirated into a disposable tip atta -
ched to the pi pette shaft.
NOTE: Disposable tips ensure maximum sa -
fe ty and eliminate possibility of cross-conta-
mination of liquid samples.
CLINIPET + pipettes have a blow-out mecha-
nism ensuring complete removal of liquid from
the tip.
CLINIPET + pipettes have a built-in tip ejector.
Using it makes removing the tip from the pipette
shaft easier, and protects against contact with
a contaminated tip. When using narrow tubes
it may be necessary to remove the tip ejector.
It is simply removed by pulling down.
The accuracy (A) and repeatability (P) of liquid
volume depends on the quality of tips used.
The values for accuracy and repeatability were
obtained using the HTL tips. Only the use of HTL
tips guarantees accuracy and repeatability
of liquid sampling.
Figure 1 shows the outside elements of the
pi pette and their materials:
A. Pipetting pushbutton Polypropylene (PP)
B.Eject pushbutton
C.Handle
D.Ejector
E. Pipette shaft
Please, get acquainted with the figure and its
des cription before reading the instruction manual.
ENGLISH
Polypropylene (PP)
Polypropylene (PP)
Polypropylene (PP)
Polyvinylidene fluoride
(PVDF)
2