Troubleshooting - DeLonghi ESAM6600 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

19 TROUBLESHOOTING

MESSAGE
FILL TANK
GROUND TOO FINE ADJUST MILL
AND
INSERT WATER SPOUT AND
PRESS OK
EMPTY GROUNDS CONTAINER
INSERT GROUNDS CONTAINER
ADD PRE-GROUND
COFFEE
FILL BEANS CONTAINER
DESCALE
PRESS
CLOSE DOOR
INSERT WATER SPOUT
INSERT INFUSER ASSEMBLY
LESS COFFEE
GENERIC ALARM
C o l l e c t i o n
MEANING
The water tank is empty or is positioned
incorrectly.
The tank is dirty or encrusted with lime
scale.
The coffee runs off too slowly.
The appliance cannot make coffee.
The grounds container is full or missing. •
After cleaning, the grounds container
has not been replaced.
With the function selected, the pre-
ground coffee has not been poured into
the funnel.
The coffee beans have run out.
If the coffee grinder is very noisy, this
means a small stone in the coffee beans
has blocked the mill.
This indicates the presence of lime scale
in the appliance.
After cleaning, the infuser has probably
been left out of the coffee maker.
The service door is open
The
button has been pressed and
the hot water spout has not been insert-
ed.
After cleaning, the infuser has probably
been left out of the coffee maker.
The ground coffee funnel is clogged.
Too many coffee beans or too much
ground coffee has been added.
The inside of the appliance is very dirty.
WHAT TO DO
Fill the water tank as described in sec-
tion 4, and insert it fully.
Rinse or descale the tank.
Turn the grinding regulator (fig. 11) one
click toward the number 7 (see section
8).
Insert the hot water spout, press the
button and run off water from the spout
for a few seconds.
Empty the grounds container and clean
as described in section 6, note 7, then
replace.
Open the service door and insert the
grounds container.
Add the ground coffee as described in
section 9.
Fill bean container.
Contact an authorized De' Longhi serv-
ice center.
The descaling procedure, described in
section 17.3, needs to be performed as
soon as possible.
Leave the service door closed and the
infuser out of the appliance, press the
pointed buttons,
then follow the
instructions displayed.
If the service door cannot be closed,
check that the infuser is inserted cor-
rectly (section 16.2 - note 1).
Insert the hot water spout (fig. 4).
Insert the infuser, see section 16.2.
Empty the funnel with the help of a knife,
as described in section 9, note 5 (fig. 16).
Select a milder taste or reduce the quan-
tity of ground coffee, then press
or
or
the coffee again.
Clean the inside of the appliance thor-
oughly, as described in section 16.2. If
the message is still displayed after clean-
ing, contact a service center.
or
to deliver
21

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido