BASE INSTALLATION - LATCH
7
CLICK
8
9
7 Place child restraint into the base. Push
down on the front of the child restraint
and handle, you will hear a click. Test
to make sure it is attached by pulling
up on the front corners of the child
restraint.
8 Check the level indicator.
No te: If the foot is in the most raised
position and the bubble is out of the
zone of your childs weight you can
place a tightly rolled towel or pool
noodle under the front end of the base
to achieve the proper recline.
9 To remove base from vehicle seat,
push in on the LATCH connectors red
buttons and remove.
24