7. Close the top cover and turn on the printer or press the feed button if
the printer is already on.
Note:
The feed button will not drive the printer to cut. The cutting
function can be executed only when the software
ready.
Feed Button
setting is
17
6. Operator Controls
Power Switch
Controls printer power
1. On : normal operation – "I" position
2. Off : the power should be turned off before connect or disconnect the
communication cables and power cables – "O" position
Feed Button
Advance the label media to first printing position
1. Press to advance a small length of continuous tape or a label
2. Press to take the printer out of a "pause" condition
Ready Indicator
Show the printers status
1. Green : printer is ready to operate
2. Blinking : printer is paused
Power indicator
Shows the power and error status
1. Off : printer power off
2. Green : printer power on
3. Blinking : error occurs
18