Assembly; Rear Wheels - BABYTREND TJ68 Manual De Instrucciones

ASSEMBLY

• Slide the retainer plate onto the front
3)
wheel. Be sure that the raised lip is
pointing toward the fork and insert it
into the slot on the fork. The tab on the
retainer plate must be lined up with the
slot before tightening the wheel (Fig. 3).
• With the wheel in position, tighten the
4)
axel nuts and tighten with standard
crescent, box, or open end wrench. You
should feel significant resistance and
the wheel should be held tightly in place
(Fig. 4).

REAR WHEELS

• Rest the stroller upside down, on the
5)
handle.
• Press the rear wheel posts into the rear
frame hub until it clicks into place (Fig. 5).
NOTE: Pull on the rear wheel to ensure
that it is securely attached to the stroller.
TIRES
• Tires are shipped un-inflated. The tires
6)
should be inflated on a regular basis to
the P.S.I. specified on each tire. Always
use a bicycle style hand air pump to
inflate the tires (Fig. 6). *not included.
5
Copyright © 2016, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Front Fork
Slot
Axel and Hub
Retainer Plate
Axel Nut
Fig. 3
Fig. 4
Fig. 5
Fig. 6
PARENT TRAY
WARNING:
Do not
place hot liquids or more
than 3 pounds in the parent
tray. Serious burns or
unstable conditions could
result.
• To attach the parent tray: align the
7)
fittings on the ends of the parent tray
with the fittings on the outsides of the
handle. Hook the hole in the parent tray.
Pull outward on the opposite end while
pushing down on the tray until locked
onto the stroller handle. Be careful not to
pinch your fingers (Fig. 7).
NOTE: Check to make sure the parent
tray is secure before using.
SEATBACK POSITIONING
• To recline the seat: loosen the strap
8)
through the buckle and adjust to the
required recline position (Fig. 8a). To
place the seat back in a more upright
position, press upward on the seat
back with one hand while pulling the
strap through the buckle with the other
(Fig. 8b).
NOTE: The upright position should be
used only for a child that is at least 6
months old. Always re-adjust the safety
harness, including the shoulder belts,
when repositioning the seatback.
Copyright © 2016, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
ASSEMBLY
Fig. 7
Fig. 8a
Fig. 8b
6