Assembly; Safety - BABYTREND SS88 Manual De Instrucciones

ASSEMBLY

ATTATCHING THE SEAT
ONLY
• approved Snap Tech™ products can
be used on the frame.
4) • Attach the seat by lining up the seat
anchors on the side of the seat with the
anchors on the stroller frame and pushing
them together until they lock securely
(Fig. 4). The seat can face in either
direction, frontward or backward.
• To take off the seat or the infant car
seat, push both release buttons on each
side of the seat anchors and lift the seat
upwards.
DO NOT remove with child in the seat.
TO ADJUST SEAT
5) • The seats can be adjusted into upright
and reclined positions. Pull the recline
button on the rear of the seat and rotate
the seat into the desired position (Fig. 5).
REMOVABLE CANOPY
6) • To attach the removable canopy: Line
up the posts on the canopy clips with the
holes on the toddler seat tubes. Attach
the canopy to the seat frame using the
hook and loop fasteners (Fig. 6a).
• Push or pull on the front edge of the
canopy while holding the rear of canopy
in place to open and close (Fig. 6b).
7
Copyright © 2016, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
BRAKES
WARNING:
stroller is not being pushed so that the stroller will not
roll away. NEVER leave stroller unattended on a hill or
incline as the stroller may slide down the hill.
7) • To engage brakes, apply downward
Fig. 4
pressure to the brake levers located on
the rear axle. The stroller might need to
be rolled back and forth to fully engage
the brake (Fig. 7).
NOTE: Check that the stroller will not
move once the brakes are properly
applied.
• To release, gently lift up on the brake
levers.
Fig. 5
TO SECURE THE CHILD
WARNING:
sliding out. Always use the safety harness.
STRANGULATION HAZARD:
Child can strangle in loose straps. Never leave child in
seat when straps are loose or undone.
8) • The shoulder straps of the 5-point
harness have 3 attachment positions.
Select the position that places the
Fig. 6a
shoulder strap level with, or below, the
top of the child's shoulders (Fig. 8a).
To adjust harness height unhook the
shoulder strap from the crotch buckle.
Feed the shoulder strap through the
harness spread slots. You can access
these slots from the rear of the seat
underneath the fabric. Feed shoulder
strap through the appropriate slot
and reattach the shoulder strap to the
crotch buckle.
Fig. 6b
Copyright © 2016, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.

SAFETY

Always set brakes when the
Avoid serious injury from falling or
Fig. 7
Fig. 8a
8