Lennox MERIT Serie Instrucciones De Instalación

INSTALLATION INSTRUCTIONS FOR BARRIER SCREEN PANEL KITS
INSTRUCTIONS D'INSTALLATION POUR ENSEMBLES PANNEAUX GRILLAGÉS
INSTRUCCIONES DE INSTALACIÓN PARA LOS JUEGOS DE PANELES DE MALLA BARRERA
KIT CONTENTS / INCLUS DANS LE KIT / CONTENIDO EN EL JUEGO
1 ea. Screen panel / panneau grillagé / panel de malla
1 ea. Language labels / Étiquette Française ou espagnol / Etiquetas
del idioma
1 ea. Instruction sheet / Feuille d'instruction / Hoja de instrucciones
BARRIER SCREEN PANEL KITS
ENSEMBLES PANNEAUX GRILLAGÉS
f i r e - p a r t s . c o m JUEGOS DE PANELES DE MALLA BARRERA
Cat. No. Model No.
No. Cat. No. Modèle
Cat. No. Modelo No.
H7726 MED/SDVI-BS
H7722 RDV-BS
TOOLS REQUIRED / OUTILS NÉCESSAIRES / HERRAMIENTAS
REQUERIDAS
None / Aucun / Ninguna
GENERAL INFORMATION
If you encounter any problems, need clarification of these instructions or
are not qualified to properly install this kit, contact your local distributor
or dealer.
Read this instruction sheet in its entirety before beginning the installa-
tion.
All of these parts may scratch and bend, great care should be used
in handling them.
ALL WARNINGS AND PRECAUTIONS IN THE INSTALLATION AND
OPERATION MANUAL PROVIDED WITH THE APPLIANCE APPLY TO
THESE INSTRUCTIONS.
TURN OFF THE APPLIANCE AND ALLOW IT TO COMPLETELY COOL
BEFORE PROCEEDING.
Hot fireplace inserts will cause severe burns. Do
not touch glass, metal frame or screen until cooled.
Never allow children to touch these areas.
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Models Where Used
Utilisè Sur Modèles
Modelos Donde Se Usa
Medina™ and SDVI
Ravenna™
WARNING
REMARQUE : LES SCHÉMAS ET LES ILLUSTRATIONS NE SONT PAS À L'ÉCHELLE.
P/N 506033-27
Rev. A, 03/2010
INSTALLATION INSTRUCTIONS
Step 1. Remove the barrier screen from the packaging.
Step 2. If an accessory face is installed on the unit, lift up on the face and
remove from the unit before proceeding with the barrier screen
installation. For detailed instructions on removing a specific
accessory face, please refer to the instruction sheet that was
supplied with the face.
Step 3. The barrier screen is designed to snap over the outside of the
glass door frame. There are three mounts on the top of the bar-
rier screen, and one more on the left and right side. Take note to
which end is the top and which end is the bottom of the screen.
See Figure 1.
Step 4. Place the barrier screen over the glass door, making sure to hook
the bottom edge first, then the side mounts, and finally snap the
top mounts into place. Ensure the barrier screen is fully seated
against the glass door frame before proceeding to the next step.
See Figures 2 and 3.
Step 5. Reinstall face assembly.
Step 6. This screen is provided with a warning label in English, located
on the bottom left front corner. If the primary language of the
home is other than English, apply one of the provided (French
or Spanish) alternate language labels over the English language
label. See Figure 4.
Three Mounts On Top
Trois attaches sur le dessus
Tres Monturas En Lado Superior
Side Mount
Back View
Attache latérale
Vue de dos
Montura Lateral
Vista Trasera
Figure / Figura 1
HEARTH PRODUCTS
KITS AND ACCESSORIES
BARRIER SCREEN KITS
Top
Dessus
Lado Superior
NOTA: LOS DIAGRAMAS Y LAS ILUSTRACIONES NO ESTAN A ESCALA.
™
Side Mount
Attache latérale
Montura Lateral