Operation Instructions For The Automatic Washer; Operation Instructions For The Manual Sink; Service - Hedson Drester Boxer Double Combo Manual De Operación

OPERATING INSTRUCTIONS FOR THE
AUTOMATIC WASHER
Empty the spray-gun of any residual paint into a separate spills-
dish.
Open the main valve for compressed air (item 7 illustration 1).
Close the lid for the sink, and open the lid for the automatic
washer.
Place the spray-gun inside (see illustration 5).
Be sure to fi t the trigger clip following illustration 6, and to
push the spray-gun up against the nozzle for the paint-channel
(item 1 illustration 5) before you lock it into position with aid of
the magnets of the trigger clip.
If you prior to cleaning prefer to remove the Air-cap and the
needle of the spray-gun, then place those items as shown by
arrow 5 in illustration 5.
Close the lid, and start the automatic wash cycle by pressing
the foot pedal No.8 in illustration 1. The spray-gun will now be
automatically cleaned for approx. 1.5 minutes with recirculat-
ing solvent.
Open the lid when the automatic wash cycle is completed. The
parts of the spray-gun can now be further manually rinsed if
desired.
By pressing foot pedal No.11 illustration 1, solvent will be fed
through the spray-nozzle placed inside the automatic washer
(item 4 illustration 5).
Connect the spray-gun to the air-line on the left side of the
machine (item 4 illustration 1), and blow out the spray-gun
through the funnel inside the automatic cleaner (item 3 il-
lustration 5). By using this funnel, you prevent the fumes from
spreading within the premises.
Finally, the spray-gun can be blown dry by using the air-gun on
the right side of the unit (item 12 illustration 1).
Close the lid after cleaning.
16025 rev 2012-02-29
OPERATING INSTRUCTIONS FOR THE
MANUAL SINK
Empty the spray-gun of any residual paint into a separate spills-
dish.
Open the main valve for compressed air (item 7 illustration 1).
Close the lid for the automatic washer, and open the lid for the
sink.
By pressing foot pedal No.10B in illustration 1, recirculating
water-based solvent will be fed through the cleaning brush
placed in the sink (item 1 illustration 7). Note that the ball-
valve on the brush (item 6 illustration 7) must be in an open
position. Use the cleaning brush to clean the spray-gun.
The spray-gun's paint channel can now be rinsed. Press the ta-
pered nozzle of the rinse-gun (item 2 illustration 7) against the
paint channel of the spray-gun. By pressing foot pedal No.10B,
and pulling the triggers on the spray- and rinse-guns simulta-
neously the paint channel of the spray-gun will be thoroughly
rinsed.
When using the rinse-gun, the ball-valve on the wash-brush
should be in a closed position.
The brush and rinse-gun in the sink can be used independently
of the automatic washer at any time.
Connect the spray-gun to the air-line on the left side of the
machine (item 4 illustration 1), and blow out the spray-gun
through the funnel in the sink (item 3 illustration 7). By using
this funnel, you prevent the fumes from spreading within the
premises.
Finally, the spray-gun can be blown dry by using the air-gun on
the right side of the unit (item 12 illustration 1).
Close the lid after cleaning.

SERVICE

Weekly:
– Remove the strainer at the bottom of the automatic washer
(item 2 illustration 5) and clean it,
Monthly:
– Remove the fi ve nozzles automatic washer and clean them
with clean solvent. (see illustration 8).
When changing drums:
– Check and if necessary clean the strainers on the suction
hoses.
do not forget to re-fi t it !
5