Switch Housing Assembly - Emerson BUILDER Serie Manual Del Usuario

BP7312-4 CF700.qxp_ BP7312 2/27/15 5:14 PM Page 9
3.11
Remove the three switch housing mounting screws
(Figure 10) from the switch housing plate.
NOTE: If you are using an Emerson light fixture
Retain the screws for future use in Step 3.13.
with your fan. Remove the screw plug from the
bottom of the switch housing cover and install the
light in accordance with the light kit Owner's
Manual. Make light kit electrical connections to blue
and white leads marked "For Light" in the switch
housing. Follow light kit instructions for wiring and
installation. Then reinstall switch housing as
outlined above.
3.12
Engage the connector of the switch housing assembly
with the motor connector (Figure 11).
The two connectors are keyed and color-coded and
must be mated correctly (color-to-color) before they can
be engaged.
Make sure the connector latch closes properly.
3. Ceiling Fan Assembly
(Continued)
SWITCH HOUSING
MOUNTING SCREWS (3)
Figure 10
SWITCH HOUSING
ASSEMBLY
Figure 11
Please contact 1-800-654-3545 for further assistance
9
SWITCH HOUSING
MOUNTING PLATE
SWITCH HOUSING
CONNECTOR
MOTOR CONNECTOR
emersonfans.com
U.L. Model No.: 52-ANT