Ceiling Fan Assembly - Emerson BUILDER Serie Manual Del Propietário

3.1
Disconnect Electrical Power to the Branch Circuit at the
Circuit Breaker or Fuse Box before attempting to install
the Ceiling Fan to the Outlet Box.
3.2
Pass the three 42" Motor Leads through the opening in
the Ceiling Cover.
Be sure the Ceiling Cover is oriented correctly
(Figure 1).
3.3
Separate, untwist and unkink the three 42" Motor
Leads.
Route the 42" Motor Leads through the Hanger
Ball/Downrod Assembly (Figure 2).

3. Ceiling Fan Assembly

!
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box before wiring. All wiring must
be in accordance with National and Local codes and
the ceiling fan must be properly grounded as a
precaution against possible electrical shock.
Figure 1
Figure 2
5
Please contact 1-800-654-3545 for further assistance
WARNING
42" MOTOR
LEADS
CEILING
COVER
42" MOTOR
LEADS
HANGER BALL/
4.5" DOWNROD
ASSEMBLY
emersonfans.com
U.L. Model No.: 52-ANT