Using The Top Tether Strap Forward-Facing; Using The Safety Harness - Diono radian 5 Manual De Instrucciones

Forward-facing lap-shoulder seat belt installation (cont)
9 – 25 kg (Groups 1, 2)
2. Feed the vehicles seat belt through the belt path under the padded seat (Fig. 2).
3. Check the seat belt has not become twisted, then fasten the seat belt by slotting
the tongue on the seat belt into the buckle on the vehicles seat (Fig. 3).
4. Push down on the bottom of the car seat while pulling all the slack out of the
belt. It is best to do this close to the buckle. Be sure the car seat does not move
more than 2.54 cm side to side, front to back at the belt path (Fig. 4).
5. Slot the diagonal section of the vehicle's seat belt through the top seat belt
guide on the top of the car seat's backrest (Fig. 5).
6. Attach seat belt lock-off clip (see page 24 for installation instructions).
1 2
4

Using the top tether strap forward-facing

WARNING:
• The use of top tether strap is recommended for all forward-facing
installations AND MUST BE used for occupants weighing 15 to 25 kg.
• When fitting the car seat in the forward-facing position, attach the top
tether to an approved tether anchorage point.
• NEVER attach the tether strap to any movable parts or mechanisms of
the vehicles seat.
If your vehicle does not have tether anchorage point, consult the owner's manual supplied
with your vehicle, the manufacturer or an authorised vehicle dealer for more information.
3
5
22
Using the top tether strap:
1. Before you fit the car seat in your vehicle, remove the top tether strap from the
storage compartment on the top of the car seat's backrest (Fig. 1).
2. Pull the adequate webbing through the tether adjuster attached to the
anchorage strap on the back of the car seat while pressing release button (Fig. 2).
3. Install the car seat in the vehicle in the forward-facing (see page 21-22) position and
find the tether attachment points, check in the vehicles owner's manual (Fig. 3).
4. Fasten the clip on the end of the tether strap over the anchorage. Tighten strap
by pulling the loose end of the tether strap until the tension indicator turns
green. See page 20 for more information (Fig. 4).
1
3

Using the safety harness

2
1
1 2
1. Loosen the harness by pulling the harness release lever
the harness release lever up, pull both of the harness shoulder straps outwards
(Fig. 1).
2. Unfasten the harness by pushing the centre red button downwards (Fig. 2).
3. Place the child in their car seat with there back firmly against the car seats
backrest. Place the shoulder straps over the child's shoulders (Fig. 3).
4. Slide the buckle tongue sections together (Fig. 4).
2
Pull to tighten
tension
indicator
4
3
4
upwards. Whilst holding
1
23