Detachable Base; Harness Buckle Location; Removing & Fitting The Harness Buckle - Diono radian 5 Manual De Instrucciones

Detachable base

WARNING:
• The detachable base MUST only be used when the car seat is fitted in
the rear-facing position.
• Do NOT use when car seat is forward-facing.
Retaining
hooks
1
Fitting the detachable base:
1. Ensure the seat section is locked in the unfolded position (see page 7).
2. Ensure the car seats adjustable seat base is in the raised horizontal position (see
page 13).
3. Align the hooked feet on the top of the detachable base and insert them into holes
in the underside of the seats base (Fig. 1).
4. Slide the detachable base towards the back of the car seat (Fig. 2).
5. Push the metal locking pin down to fasten the detachable base to the car seat (Fig. 3).
UNLOCKED
LOCKED
Removing the detachable base:
1. Lift the metal locking pin upwards to unlock the detachable base (Fig. 3).
2. Slide the detachable base towards the front of the car seat.
3. Pull the detachable base off the base of the car seat.
Tip: Slot the detachable base into the top of the car seat when transporting (Fig. 4).
2
3
10

Harness buckle location

IMPORTANT:
Check to ensure the harness buckle is fitted in the correct position for the age/weight
of the child you are putting in the car seat.
Position 1
Group
Group 0+, 1
Groups 1, 2
IMPORTANT:
When changing the position of the harness ensure the webbing and metal retainer are
fitted as shown in the diagram below.
Removing & fitting the harness buckle
1
4
1. Ensure the seat section of the car seat is locked in the unfolded position (See
pages 7 and follow the instructions for unfolding the car seat).
2. Unbuckle the harness by sliding the release button downwards (Fig. 1)
3. Push the strap on the bottom of the buckle down through the base of the car seat until
you can see the metal buckle retainer through the seat belt slot in the seat section (Fig. 2).
4. Slide your hand through the seat belt slot under the seat and grip the metal
buckle retainer. Turn the retainer until it is vertical and push through the slot in
the plastic frame, padded insert and through the slot in the cover (Fig. 2).
Position 2
Position 3
Child Weight
From Birth to 18 kg
From 9 to 25 kg
Position 1
Position 2
Position 1
Position 2
2
11
Buckle position
Use Position 1
Use Position 2
Position 3