Infant Pad And Head Cushion; Side Impact Head Support; Reclining Base Adjustment; Infant Pad - Diono radian 5 Manual De Instrucciones

Removing & fitting the harness buckle (cont.)
IMPORTANT:
If you have large hands, you may find it easier to partially fold the seat first (See steps
1-5 on pages 7-9 of this manual).
5. Then, slide your hand through the gap at the back of the seat to rotate the metal
buckle retainer and slot it through the seat base, padded insert and fabric cover
(Fig. 4).
4

Infant pad and head cushion

1
Fitting the infant pad:
Remove the harness buckle as shown on page 12. Place the infant pad on the seat and select the
best buckle slot in the pad, depending on the height of your child and refit the buckle (Fig. 1).
Fitting the head cushion:
Fasten the velcro pad on the head cushion to the pad on the back of the infant pad. Pass
the straps on the back of the head cushion behind the centre panel of the cover and
fasten together (Fig. 2).
Side impact head support and adjustment
1
2
2
12
Correct position: When using the top two harness positions, the bottom edge of the
head support must be aligned with the lower edge of the jaw but above the shoulders.
When using the lower three harness positions, raise the head support to the top position.
Lowering the head support: Place your hands on the top of the head support
towards the back and push firmly down (Fig. 1).
Raising the head support: Place your hands on the underside of the head support
towards the back and pull upwards (Fig. 2).

Reclining base adjustment

WARNING:
• Do not adjust the base when using the detachable base in the rear-
facing position.
• ONLY use the reclining base when fitting the car seat in the forward-
facing position 15 to 25 kg.
A B C
2
When to use the reclining base:
Due to the angles of certain vehicle seats and backrests you may need to change the
angle of your car's seat base to achieve a satisfactory fit.
Note: The seat's base section must be in the unfolded position before adjusting the
reclining base.
NEVER attempt to adjust the reclining base once the car seat has been fitted in the vehicle.
DO NOT engage the reclining base in this configuration (Fig. C)
1
3
13